Guides · Room requirements by launch monitor
How Much Room Does a Foresight GC3 Need Indoors?
Published
Foresight's GC3 pages list no minimum room size for the unit. The GC3 measures the shot beside the ball with three high-speed cameras and uses a compact 7-by-10-inch hitting zone, so it does not need open floor behind the golfer for a radar unit. Your room dimensions are set by your swing, the net or impact screen, the enclosure, and the projector or display.
The GC3 only needs a small area around the ball
The GC3 sits next to the hitting area and watches a 7-by-10-inch zone. That is the biggest space advantage over a rear-mounted radar system: there is no requirement to leave six or eight feet behind the golfer just for the launch monitor.
A room that is too short for some radar units may therefore work with a GC3. The zone is small, though: Foresight's own comparison table gives the GCQuad 18 by 14 inches, so ball placement on the GC3 has less room for error.
Your swing sets the real minimum
Check ceiling height and side clearance first. Stand on the actual hitting mat, use the longest club you expect to swing, and make normal driver swings without protecting the ceiling or wall.
Then place the screen or net. Impact screens need their own clearance behind the fabric, and the hitting position has to sit far enough back for safe ball containment and comfortable play. The GC3 itself is 6 inches wide, 5 inches deep, and 12 inches tall.
Plan for right- and left-handed players
Because the GC3 is a floor unit beside the ball, switching handedness can mean moving the launch monitor to the opposite side of the hitting area.
That is easy on an open mat. It becomes less convenient if the unit is boxed in by cabinetry, recessed into the floor, or connected with cables that only reach one side. If both left- and right-handed golfers will use the simulator, leave a clean path for the device to move.
Club data adds a small setup step
Club data on the GC3 comes from the Club Markers included in the box. Foresight lists club head speed, smash factor, club path, and angle of attack as the club measurements. That does not change the room size, but it matters if several people will rotate through the simulator with different clubs.
If you want club path and angle-of-attack data, every club you want the GC3 to read needs markers.
A compact launch monitor still needs a full simulator room
The GC3 is small enough to sit beside the ball without dominating the floor plan. The golfer still needs room to swing, and the screen, enclosure, projector, and seating can easily become the larger space consumers.