Guides · Room requirements by launch monitor
How Do You Set Up SKYTRAK Indoors So It Reads Shots Reliably?
Published · Updated
Set SKYTRAK level with the hitting surface, parallel to the target line, and start with the ball or tee base on the red laser dot on models that use it. Ball position can need a small adjustment for different clubs, so the dot is a starting point rather than a rule for every shot. Make height and alignment repeatable before changing connection or gameplay settings.
Mat height first
SKYTRAK sits next to the ball, so a small height error matters. Say the hitting mat is two inches above the concrete and the launch monitor stays on the floor. Now the cameras are looking at the strike from the wrong level.
Bring the bottom of the unit even with the top of the hitting surface. SKYTRAK's alignment guide has you use Device Level to zero both tilt and roll. A protective case with adjustable feet can do that, and so can a rigid platform. Avoid a soft or makeshift riser that can tilt from one shot to the next.
The red dot and the target line
On SKYTRAK models with the red laser dot, start with the ball on the dot. For a teed shot, put the base of the tee there instead of guessing where the raised ball should sit. SKYTRAK's Tips for Use Guide says moving the ball 1 to 2 inches behind the laser may help with higher-speed clubs such as drivers and woods; moving it 1 to 2 inches in front may help with lower-speed clubs such as wedges. Try those adjustments if the device misses particular clubs.
Then look at the target line. SKYTRAK should be parallel to the line you mean to hit on, and an alignment stick, a tape line, or a weighted string at the net shows that far better than your eye can. SKYTRAK notes in its alignment guide that it removed Alignment Mode from the main app in version 5.4 and later, although it remains available through SKYTRAK Lite on a mobile device. Check the physical line first.
If you're hitting off-center to a projected screen, the same guide tells you to use Settings > Adjust Camera to line up the practice range's center line with the red dot. That display adjustment doesn't replace aligning the unit with the actual target line.
Nothing in the cameras' way
Towels, shoes, loose cables, the edge of a raised platform: keep all of it out of the hitting zone. A protective case makes sense with the monitor this close to the ball, as long as it doesn't cover the cameras, laser, or status lights.
SKYTRAK's use guide warns that direct sun into the optic lens can cause inconsistent shot capture. If readings go wrong at the same time each day, close the shade and hit a few easy shots before you open the settings. It also recommends a clean, white ball with its logo or marked line facing the unit for better spin readings.
When a shot goes missing
A shot doesn't register, or starts off in an odd direction. Run the physical checks. Is the unit at mat height? Level? Parallel to the target line? Is the ball in the expected hitting area, and is anything blocking the view?
Connection settings and the app come after that. A launch monitor nudged out of place can send you looking for a software problem that isn't there.
Same spot, every session
SKYTRAK is portable, but a home simulator gets tiresome if you rebuild the setup each time. A small tape mark, a fitted recess, or a fixed platform puts the monitor back in the same place at the same height.