Guides · Room design and everyday use
How Do You Hide and Secure Cables in a Golf Simulator Room?
Published · Updated
Keep cables out of the stance, the swing path, and anywhere a golf ball can hit them. In a permanent room, put outlets close to the equipment and route signal cables through suitable raceway, conduit, or an approved in-wall path. If a cable must cross the floor, use a cover approved for that cable and traffic, well away from the mat; a cover doesn't make an extension cord suitable for permanent wiring.
Mark every device on the plan
Before you buy any cable, put the projector, computer, launch monitor, TV or monitor, speakers, router, lights, and charging spots on the room plan. The routes are easy to see once everything has a place.
Skip that step and you end up with three extension cords across the same doorway.
Nothing loose near the mat
The floor around the golfer should be empty. Loose USB, charging, HDMI, and extension cords trip people, and one snag can pull an expensive device off a shelf.
If a floor-mounted launch monitor needs power, bring the cable in from the safer side and secure the last stretch with a suitable cable holder so it can't slide under a shoe. Don't staple, pinch, or crush a power lead. Keep extension cords temporary, within their load rating, and out from under carpet, turf, and furniture. CPSC household extension-cord safety
Long runs go up the wall
Projector HDMI and Ethernet are the obvious runs to take up the wall and across the ceiling. Surface raceway does the job in a lot of rooms, and you can open it later when a cable needs replacing, which you can't do once it's sealed behind drywall.
Signal cable inside a wall or ceiling has to be rated for that use and meet local rules. Keep power and signal wiring separated as the installation instructions and local code require. Never bury an ordinary extension cord in a wall or use it as permanent wiring in a raceway; leave any new outlet or in-wall power run to a licensed electrician. Local residential code controls the permanent installation. OSHA flexible-cord restrictions
A long HDMI run is its own problem
A six-foot HDMI cable from a PC to a monitor is easy. A long run to a ceiling projector at 4K or a high refresh rate is a different job. A cable that can't carry the required signal can give you black screens, dropouts, or a lower supported resolution.
Buy for the real length and the signal you intend to send, and check the cable's certified performance category rather than relying on a vague version label. Test the full run at your intended resolution and refresh rate before closing the wall. HDMI cable categories In a finished room, conduit you can get back into is worth more than the few dollars saved on a cheaper cable.
Label both ends
Label both ends of every HDMI, Ethernet, USB, and power-adapter lead before you bundle them. Leave enough access to swap out the computer, projector, or launch monitor without opening a finished wall.